build:hardware
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
build:hardware [2010/11/13 14:06] SLUUG Administration |
build:hardware [2010/11/13 14:16] (current) SLUUG Administration |
||
|---|---|---|---|
| Line 33: | Line 33: | ||
| To run the Compaq System Configuration Utilities, we inserted the CD in the CD-ROM drive and booted the system. When the system failed to boot, at the prompt "Press F1 to continue, F10 to run System Partion" (System Partition utility in Windows started but failed to run), pressing F1 resulted in successful boot from the CD. | To run the Compaq System Configuration Utilities, we inserted the CD in the CD-ROM drive and booted the system. When the system failed to boot, at the prompt "Press F1 to continue, F10 to run System Partion" (System Partition utility in Windows started but failed to run), pressing F1 resulted in successful boot from the CD. | ||
| - | |||
| ===== Specs ===== | ===== Specs ===== | ||
| Line 43: | Line 42: | ||
| ^HD:| 4 x 18 GB, attached to RAID controller| | ^HD:| 4 x 18 GB, attached to RAID controller| | ||
| ^NICs:| Compaq NC3131 (2 in **bud**, 1 in **budlight**)| | ^NICs:| Compaq NC3131 (2 in **bud**, 1 in **budlight**)| | ||
| + | ^Case:| 4U rackmount (deep, probably 26")| | ||
| + | ^PSU:| Redundant hot-swappable power supplies| | ||
| + | |||
| + | ^ RedHook ^^ | ||
| + | ^Manufacturer:| Compaq (now HP)| | ||
| + | ^Model:| ProLiant DL580R01| | ||
| + | ^CPU:| 4 x 700 MHz Pentium III| | ||
| + | ^RAM:| 3 GB| | ||
| + | ^HD:| 4 x 36 GB, attached to RAID controller| | ||
| + | ^NICs:| Intel Pro 100 (1 single, 1 dual, total 3)| | ||
| ^Case:| 4U rackmount (deep, probably 26")| | ^Case:| 4U rackmount (deep, probably 26")| | ||
| ^PSU:| Redundant hot-swappable power supplies| | ^PSU:| Redundant hot-swappable power supplies| | ||
| Line 55: | Line 64: | ||
| ^Case:| 6U (?) rackmount (deep, probably 26")| | ^Case:| 6U (?) rackmount (deep, probably 26")| | ||
| ^PSU:| Redundant hot-swappable power supplies| | ^PSU:| Redundant hot-swappable power supplies| | ||
| - | |||
| ===== Problems ===== | ===== Problems ===== | ||
| Line 65: | Line 73: | ||
| The power supply fans on budlight would not start up when we installed the systems at Primary Networks. The BIOS POST noticed this (reported them as fans #5 and #6) and prevented the system from booting. We removed the fan module (which attaches behind the power supply) and re-seated it. The system then started fine. The fan problem has proved to be an ongoing issue. | The power supply fans on budlight would not start up when we installed the systems at Primary Networks. The BIOS POST noticed this (reported them as fans #5 and #6) and prevented the system from booting. We removed the fan module (which attaches behind the power supply) and re-seated it. The system then started fine. The fan problem has proved to be an ongoing issue. | ||
| + | |||
| + | On RedHook, battery for RAID array accelerator card was low on first startup, and is attempting to charge. Will check later to see if it gives good indication. | ||
| + | |||
| + | RedHook initial attempt to boot with Compaq System Configuration Utilities version 8.6 was unsuccessful (once we were successful at selecting the CD as boot source). Download page and ISO filename indicated 32 bit kernel, but CD refused to boot with indication it was using a 64 bit kernel. Fixed problem by downloading SmartStart v7.1 disk (see above for URL). | ||
build/hardware.1289678772.txt.gz ยท Last modified: 2010/11/13 14:06 by SLUUG Administration
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
